Undeliverable Message

[MAILER-DAEMON at seb.varian.com]

To:            <diy_efi at coulomb.eng.ohio-state.edu>
Cc:            
Subject:       Undeliverable Message

Message not delivered to recipients below.  Press F1 for help with VNM
error codes.               

	VNM3043:  David Atchley at m2000@TFS_BLDG_6
To:            <diy_efi at coulomb.eng.ohio-state.edu>
Cc:            
Subject:       Re: Q: dual ended ignition coil

Message not delivered to recipients below.  Press F1 for help with VNM
error codes.               

	VNM3043:  David Atchley at m2000@TFS_BLDG_6
ARTHUR OKUN writes:
> 
> use a standard coil and make a Y splitter using some some glass epoxy 
> board and some sutible studs and  insulate the thing with silicon 
> rubber    all the dual coil is in my estimation is an standard hei coil
> with two outputs in parellel    " there's a schematic in my buicks 
> chilton"

wrong.  the dual terminal coils are in series...  the current flows
out one terminal, down a plug wire, across a spark plug, through the
head, across another plug, back up another plug wire, and back into
the coil.

-- 
Jonathan R. Lusky                        lusky at knuth.mtsu.edu
http://www.edge.net/~lusky/                 (615) 726-8700
-------------------------------------   ------------------------------
68 Camaro Convertible - 350 / TH350  \_/ 80 Toyota Celica - 20R / 5spd