Injectors and fuses
Tommy.Palm at oron.ds.sll.se
Tommy.Palm at oron.ds.sll.se
Wed Jan 17 20:29:45 GMT 1996
>>
>> For anyone out there!
>> =
>> I am currently connecting a new efi system and I was wondering wh=
ether =
>> to include a fuse in the common 12V supply to all the injectors, =
just =
>> to avoid the injector drivers in the efi unit stuffing up if one =
of =
>> the injectors short out and draw major current through the efi un=
it. =
>> Any thoughts?
>> =
>> =
>> Dan dzorde at aesprodata.com.au
>> =
>>
>
>Dan,
> Yes a good idea. Size of fuse will depend on whether you are usin=
g 16
>ohm or 3 ohm injectors. Better than blowing a track off the pcb !
> regards,
> Mark Boxsell
> MRB Design
> Sydney Australia
>
I agree!
In the 2.5 ohm systems i have checked they don't take more than 1-
1.5amp/injector. Around 2 amp should bee a good choise since the most
transistors used have a much higher max limit (this concerning 1 transis=
tor per
injector).
regards,
Tommy Palm
tommy.palm at oron.ds.sll.se
Sweden
More information about the Diy_efi
mailing list