It Howls with small throttle bodies

[Michael Manry]

Does anyone have the address for Autronic??? I tried looking them up thru 
a couple of sources and struck out .
Thanks

Mike Manry
ShadeTree racing

On Thu, 31 Oct 1996, Jeremy Pronk wrote:

> On Wed, 30 Oct 1996, Doug Robson wrote:
> 
> > I installed an Autronic SMC computer and individual 50 mm throttle
> > bodies. Result 160-170 bhp  :(     ( sad face ).
> > I have recently had a set of 45 mmm bodies made with same diameter at
> > ram intake end but 45 at butterfly. result 205 bhp and more torque.
> > Drove it on track on Sunday and it howls. Im amazed at the difference of
> > 5mm makes. all other parts of the engine are unchanged since previous
> > set ( except bearings).
> 
> I have an haltech E6 installed on my alfa. I used to run twin webers
> (36mm), but with the efi it is now running twin weber 45mm throttle
> bodies. I have to say that "takeoff" isnt that much fun (esp. up hills).
> It goes really well above about 3500rpm+, seems to get a lot of torque
> steer? as well if I hammer it.
> 
> You wouldn't happen to know where I could get some chokes made up? I
> really want to choke them down to ~40mm, because this is the "Drive
> around" car (ie, I am not interested in the 2000rpm power band > 5000rpm). 
> 
> 
> bye,
> 
> Jeremy, Sydney AUSTRALIA 
> http://www.st.nepean.uws.edu.au/~jpronk/
> '83 AlfaSud Ti (Haltech E6 efi)
> 
>