Inexpensive EPROM programmer

Brad Sheridan sheridan at vanceandhines.com
Thu May 1 00:34:57 GMT 1997


>
>I use one made by GTEK (not the accelerometer being discussed).
>Runs off RS-232, has built in ASCII functions so it can
>be used with a terminal only.  Can download and program
>lotsa devices.  Don't have it here -- one of our faculty
>has taken it.  I may never see it again  8^).  Seems it
>costs about $400 or so.

 Is that the 9000A? That one was $599, and there was also a Needhams SA-10
that was $499. There were several in the $200 range, but every single one
was either the parallel port type or had an ISA card. The SA-10 is a stand
alone with serial and parallel ports. It seems odd that noone would have a
less expensive serial port capable programmer, I don't think designing or
making it would be any more difficult than the parallel port version. I
guess I'll try the Needhams one, since I have had good luck with them in
the past. Thanks for your help.

Brad





More information about the Diy_efi mailing list