ALDL Interface Schematic

[peter paul fenske]

Hi All

The schematic is in Tango Schematic Format. If anyone
else wants a different format tell me how to put in that
format and I will do it. The SO1 file though takes very little
space unlike a PCX or whatever.

When I get some time I will post the comm software crude 
though it is.

CU:peter

At 07:34 PM 5/11/97 -0400, you wrote:
>Hey Peter,
>
>BTW, what file format is the DB9.S01 in?  Tried several conversion 
>utilities, but nothing picked it up :)
>
>Thanks!
>
>
>Frederic Breitwieser
>Homebrew Automotive Mailing List
>Website: http://members.aol.com/fjb203/index.htm
>Email: frederic.breitwieser at mcione.com & FJB203 at aol.com
>Bridgeport, Connecticut
>
>
>
>On Friday, May 09, 1997 2:11 AM, peter paul fenske [SMTP:pfenske at direct.ca] 
>wrote:
>> Howday All
>>
>> There was a bit of interest in the interface I used to allow a PC
>> to monitor the COM between a ECM and a TECH 1.
>>
>> Included should be the schematic.
>>
>> The PC can use any com program with the baud rate set close to
>> 8192 baud. I will include one later when I get some time.
>>
>> The test device must send the first five bytes I posted.
>> The ECM will return with the bytes I posted.
>>
>> This is block com not continuous. The data tester must request each
>> frame.
>>
>> GL:peter
>>  << File: DB9.S01 >> 
>
>