Software for simple fuel-only system

[Terry Sare]

     Alex,
     
     I would like a copy of the software please.
     
     
     I bought two 332 boards and parts kits. Currently, I don't seem to 
     have the time to do anything with them. I am willing to part with 1 
     complete kit for cost + shipping to AU??? I will have to look it up 
     but I think it was around $135.00 (US)
     
     Terry Sare
     terry_sare at dell.com


______________________________ Reply Separator _________________________________
Subject: Software for simple fuel-only system
Author:  diy_efi-owner at esl.eng.ohio-state.edu at dell_unix
Date:    11/11/97 8:50 AM


Hi..
     
I a year ago (or so) I developed a '332 based fuel only ecu system for a 
friend of mines datsun rally car. The system was very simple using only 
throlle position as a load sensor, and a points signal for timing.
     
(It has a few other features such as a "pot" that changes mixture on the fly 
which is VERY usefull for on the DYNO, rev limit etc)
     
However it worked very well, and his car is now one of the fastest datsun 
rally cars in australia.
     
I think the software I wrote would be very easy to get going on your 
efi332 board with the minimum of effort. My hardware was just a 332, a 
small EEPROM and a few ADCs and buffers. Im not sure but I think it would 
run on a efi332 CPU with no RAM installed as it only uses the 332 
internal RAM. (Not sure about flash/BDM implications).
     
Im am happy to give my sourcecode (which uses a gcc setup very similar to 
the one it seems you guys are using) to anyone who wants it.
     
On a second note. I want a efi332 CPU board to play with. I saw that all 
your group buys are closed. Is there any way I can get a bare PCB (or 
even say 5) for cheaper than going to my local PCB manufacturer and 
paying $500 (AUS) for a prototype run of 15 ?
     
Alex Brown