Software for simple fuel-only system
sjacobs914 at Juno.com
sjacobs914 at Juno.com
Wed Nov 12 01:33:09 GMT 1997
I would love to know more about your software and source code. Also do
you have anymore details on your board configuration you used.
Take care,
Stephen Jacobs
SJacobs914 at Juno.com -- or -- 102036.2004 at Compuserve.com
On Tue, 11 Nov 1997 08:50:55 +1100 (EST) Alex Brown <agb at lab.cea.com.au>
writes:
>
>Hi..
>
>I a year ago (or so) I developed a '332 based fuel only ecu system for
>a
>friend of mines datsun rally car. The system was very simple using
>only
>throlle position as a load sensor, and a points signal for timing.
>
>(It has a few other features such as a "pot" that changes mixture on
>the fly
>which is VERY usefull for on the DYNO, rev limit etc)
>
>However it worked very well, and his car is now one of the fastest
>datsun
>rally cars in australia.
>
>I think the software I wrote would be very easy to get going on your
>efi332 board with the minimum of effort. My hardware was just a 332, a
>
>small EEPROM and a few ADCs and buffers. Im not sure but I think it
>would
>run on a efi332 CPU with no RAM installed as it only uses the 332
>internal RAM. (Not sure about flash/BDM implications).
>
>Im am happy to give my sourcecode (which uses a gcc setup very similar
>to
>the one it seems you guys are using) to anyone who wants it.
>
>On a second note. I want a efi332 CPU board to play with. I saw that
>all
>your group buys are closed. Is there any way I can get a bare PCB (or
>even say 5) for cheaper than going to my local PCB manufacturer and
>paying $500 (AUS) for a prototype run of 15 ?
>
>Alex Brown
>
More information about the Diy_efi
mailing list