NC-converting MathCAD files

[Andris Skulte]

I just did quite a few calculations determining the fuel delivery needed
for the twin turbo project in MathCAD, and was wondering if there was a
way to convert it into a GIF, JPEG, or table so I could put it on the
homepage.

The good news is that 30 lb/hr injectors at 60 psi will support my
estimated 450hp once the twin turbos are on. I can use them now too if I
want to, with a somewhat rough idle. I'm guessing that the ECM will
lower the block learn values and compensate a little, for a shorter duty
cycle. I can also lower the fuel pressure a bit to lower the fuel
delivery.

The URL for the MathCAD file is
http://www.eecs.tufts.edu/~askulte/ttt/cfm_inj.mcd

Thanks for any help. If this is an inappropriate question for the
DIY_EFI list, let me know, and I'll find out some other way.

Andris