fuel filter fittings

[dzorde]

I just use a standard Bosch FI filter, 5/16" flared pipe out of each end.

Dan     dzorde at geocities.com
 
>Hi John
>
>It may be ugly but I use screw type fuel injection clamps
>two of em and higher pressure gas line to link the pieces..
>
>Other wise there is a fram filter which uses normal 3/8 flared
>ends for FI..
>
>gl:peter
>
>At 11:28 PM 10/28/97 -0500, you wrote:
>>--------
>>
>>I'm trying to use a stock GM fuel filter ('88 tpi Camaro) in my
>>efi engine swap, but I'm having trouble with the fittings.
>>These are the ones with the o-ring seals and seem to be
>>metric. Are these called siginaw fittings? I would like to
>>put this inline with the steel tubing, but I only have a
>>single/double flare tool. What's the best way to connect
>>this without buying a new flaring tool nor having a handful 
>>of adaptors? (Anyone know, off hand, what one of those tools
>>cost?)
>>                                       John S Gwynne
>>                                          Gwynne.1 at osu.edu
>>__________________________________________________________________________
_____
>>               T h e   O h i o - S t a t e   U n i v e r s i t y
>>    ElectroScience Laboratory, 1320 Kinnear Road, Columbus, Ohio 43212, USA
>>                Telephone: (614) 292-7981 * Fax: (614) 292-7297
>>--------------------------------------------------------------------------
-----
>>
>>
>>
>>
>
>