Weber - Marelli ?
Kapocs Attila
KAPOCS at novserv.obuda.kando.hu
Wed Dec 2 07:04:01 GMT 1998
Axel,
Here is what I promised:
35 pin connector
Lancia Dedra 1995 turbo (Delta has the same ECU and engine)
1-ground
2-lambda-signal
3-ground for crankshaft position sensor
4-signal from cranksaft position sensor (4 signal each revolution 90
degree per one)
5-ground for phase (cylinder select) sensor
6-ground for diagnostic connector
7-?
8-for diagnostic connector
9-CO potentiometer (if present)
10- nc (not connected)
11-signal ground
12-Check Engine light
13-nc
14-nc
15-signal from MAP sensor
16-BPC (Boost Pressure Control) Valve control
17-signal from throttle potentiometer
18-control for 4th cylinder injector
19-ground
20- positiv voltage from main relay (present when ignition is on)
21-Air Conditoner
22-Knock sensor signal
23-phase (cyl.identification signal)
Two signal each two revolutions, assimetric.
I_ this is the pattern for the sensor like an "L"
24-ground for ignition module pin 3
25-control for ignition module pin 6
26-nc
27-diagnostic connector
28-control for fuel pump relay
29- signal from Engine coolant temperature sensor
30-+5V for throttle position sensor and for MAP sensor
31-Signal from Air Temperature Sensor
32-Control for 2nd cylinder Injector
33-Control 3rd cylinder Injector
34-Control for IAC Valve
35-Control for 1st cylinder Injector
I hope this will help.
Regards
Attila Kapocs
More information about the Diy_efi
mailing list