Buiding a Map

[Greg Hermann]

>OK, Ive got a ecm (aftermarket) that uses pulse width in it's tables,
>for fuel.  I have some oem tables that are VE.  Knowing that the oem
>are about 8.3msec at 6,000 off the bench testing then if it was a
>83%VE then could I just use the rest of the numbers as units of msec., for
>getting a rough calibration to start tuning with.
>  Or is there once again alot missing.  I realise this would be maybe
>hardly run able, but just looking for a starting place.
>Thanks in advance
>Bruce

Should work pretty darn well--curve will be same shape, the one point that
you calibrate it at should get the rest of it to where it belongs.

Regards, Greg