DIY Fiberglass intake/plenum.

[Tony Bryant]

> From:          Robert Humphris <r.humphris at indigo-avs.com>
> To:            "'diy_efi at efi332.eng.ohio-state.edu'" <diy_efi at efi332.eng.ohio-state.edu>
> Subject:       RE: DIY Fiberglass intake/plenum.
> Date:          Fri, 13 Feb 1998 10:37:05 -0000
> Reply-to:      diy_efi at efi332.eng.ohio-state.edu

> By the time that all this has been done, would it not have been easier
> to form a mold from high density foam and polysterine, and cast an
> aluminium manifold?  The equipment needed to do this would not be that
> specialised, as we used to make casts at school when I was 14 years old.
> 

You (or someone else on the list) wouldn't be able to give us a quick 
rundown (i.e. crash course) on the technique, and its pitfalls? 


'71 510 Daily driver
'72 510 Race car
'85 V12 XJ-S Garage ornament