1949 validation

[Sandy]

Look at the schematic for the SUBDRIVER on the FTP site, It has all the
info for parts that you will need. To drive saturated injectors stick with
the peak and hold values they will do just fine. The parts are easy to get
as well. The key to the sense circuit is that they should all have be made
with some precision components, ie at least 5%, as each channel should be
matched, BUT for saturated injectors, it dosent really matter that much as
the limit will never be reached.

Sandy

At 04:52 PM 2/18/98 PST, you wrote:
>In the archives Seth Allen mentioned doing some testing using 
>a 1949, and used a .47 ohm sensing resistor, and 15K, and .1
>mfd cap. are these as good of values as any?.  If it is for
>sensing is it really critical?/and would it really matter if for
>peak+hold vs saturated injectors?.  After the thread about
>switching types, this would be good for either right?.
>TIA  Bruce   Happiness is 12's in the 1/4 mile
>                    30+MPG at 70 MPH  Perfect driviablity
>                    1.1+ Lat G's  60-0  in <100ft
>                    A perfectly tailored Cone Shaped Hat  
>
>