Fixing cut harness

[xxalexx at ix.netcom.com]

> Date:          Sun, 21 Jun 1998 10:25:37 -0400
> To:            diy_efi at coulomb.eng.ohio-state.edu
> From:          Frederic Breitwieser <frederic.breitwieser at xephic.dynip.com>
> Subject:       Re: Fixing cut harness
> Reply-to:      diy_efi at efi332.eng.ohio-state.edu

> >I've found braded wire to get brittle when soldered. Is there a way around
> >this? 
> 
If you like chemicals, spray and brush clean with a flux remover,
let dry then spray with a  silicon protective coating for electrical 
and PCB's
alex