[nc] Win DRM 383 Grand Sport Corvette #351 (fwd)

Alain Toussaint alaint at boisfrancs.qc.ca
Wed May 13 04:41:59 GMT 1998


good luck,wish i had 50$,i know it's off topic but then,on such a
thing,it's worth a forwarding

Alain

p.s.check the spec of the motor,totally awesome

-----------------forwarded message---------------------------------------

A total of 1000 tickets at $50.00 will be sold to raffle off a Doug Rippie
Motors 383 Grand Sport Corvette.  The drawing will be held the evening of
July 28, 1998, and the planned site of the drawing will be in the parking
lot of Fuddruckers in Lake Forest, CA.  You need NOT be present to win the
car.  I have already bought one of the tickets, and I intend to win this car. ;)

If you would like to win this car, call the following telephone number:
(949) 360-9004.

1996 Grand Sport Corvette Coupe #351 of 750.
New 383 CID LT4 Race Motor
Only 3000 miles on new motor
12800 miles on the car

The following list of modifications have been done to the motor and the car.

Suspension
-------------------
1) Hiem Jointed Sway Bars Front and Rear Fully Adjustable
2) Polyurethane Bushings Front Complete
3) Adjustable Lower Racing Strut Rods Hiem Jointed
4) Steel Braided Lines on All 4 Calipers
5) Adjustable Brake Bias Spring in Master Cylinder
6) Carbon Metallic Racing Brake Pads
7) Kumho V7000 Racing Tires
8) Road Racing Alignment
9) Custom Racing Valved Bilstein Shocks
10) Solid 30 mm Front Sway Bar and 25mm Rear Sway Bar

Drivetrain
---------------------
1) Balanced and Blueprinted Driveshaft and Half Shafts
2) HD. Spicer Solid Steel U Joints
3) Single Mass Clutch w/ 15 lb. Lighter Flywheel
4) Dual Friction Centerforce Disk and Pressure Plate

Motor
---------------------
1) 383 CID 12.50:1 DRM Race Motor--All Parts Balanced to (0.00)
2) 4 Bolt Main LT4 Cast Iron Block Blueprinted Race Prepared
3) Light Weight 4340 Forged Steel Callies Crankshaft 3.750 Stroke
4) JE Pistons 4.030 Short Skirt w/ Speed Pro Rings
5) Pro Flow Manley Stainless Steel Valves 2.02 Intake 1.60 Exhaust
6) Crane Triple Springs with 3/8" Retainers
7) Chrome Moly Push Rods
8) AFR Hydra Rev Kit Good for No Valve Float to 9500 RPM
9) Custom Roller Cam Shaft, Specs Are for the Winner Only!
10) Crane Gold 1.6 3/8" Rockers w/ Hardened Guide Plates
11) Custom Race Port and Polished LT4 Heads
12) Huge Custom LT4 Ported Intake Manifold Matched to the Heads
13) Eagle ESP 3D Light Weight H Beam X-rayed Race Rod 6.00"
14) Mains, Rods, Rockers, Heads Are All Fastened w/ Top Quality ARP
15) 1050 CFM ASM Throttle Body
16) 2 High Volume Fuel Pumps
17) Ram Air Kit with Custom Sooth Bore Air Intake Housings
18) High Volume Oil Pump Mellings
19) Custom 7 Qt. Road Racing Oil Pan.  Motor Holds 10 Qts.
20) HD. Oil Cooler with Electric Fan and a System 1 Oil Filter
21) Custom Long Tube Tri Y Headers 1-3/4" Collector
22) Custom 3 Inch Mandrel Bent Exhaust w/ Hooker Aero Chambers
23) DRM Programmed OBD II Computer w/ Locked VE Tables
24) MSD Ignition Box
25) Adjustable Fuel Pressure Regulator
26) Hal Meter w/ Dual O2 Sensors
27) Line Locks
28) 150 HP NOS Wet System 20 lb. Bottle w/ Purge
29) 1.75" 0.095 Wall Seamless Tubing Roll Bar
30) 5 pt. Harness on Both Seats
31) Lots of Spare Parts---Too Many to List

This car is currently set up for autocross in SCCA Solo2 Events in Class BSP
or BP
This car is intended off highway use and not (currently) smog legal
Only 1000 raffle tickets will be sold at $50.00 each
Car is raffled as is with no warranty
All taxes local, state, or federal are the winner's responsibility
All licensing and applicable DMV fees are assumed by the winner
The car is currently registered, and tags expire in April of 1999

For ticket information, call (949) 360-9004






More information about the Diy_efi mailing list