0 280 150 215 flow rate

Tony Cooper tony.cooper at virgin.net
Thu May 21 09:23:25 GMT 1998



Bruce Plecan wrote:

> From: Tony Cooper <tony.cooper at virgin.net>
>
> >> Over on another list there was some actual testing done along these
> >> lines, and they went to 100PSI with the output predicted with the
> >> "standard" formula ie (off the top of my head) the square root of
> >>( P1/P2)  BRACKETS ADDED.
> >>   Also the F1 group supposedly runs 5-7 bar.
> >> I would imagine two problems at these pressures, injector seat wear,
> >> and needing to maintain 85% PWM.  I forget the frequency they used
> >> in above testing, but I think they also maintained the 85% figure.
> >> HTH
> >> Bruce  nacelp at bright.net
> >Hi Bruce,
> >Would it be possible to verify the formulie SQRT(P1/P2) please
>
> yes, valid
>
> >Also, where is the 'other' group that you quote???
>
> syty at syty.org  web site at like www.syty.org or some such
> >
> >Thanks in advance
> >Tony
> >Sent By Tony Cooper.
> >email: tony.cooper at virgin.net
> >Allow at least 10 working minutes for reply. ;)
> >
> Hmm, I now have to quote sources, and be reminded of things..
> I must be slipping........
> Cheers
> Bruce   Must be the medications, can't be because of the Cone
>              Shaped Hat, or can it????????.

 Thanx Bruce....

--
Sent By Tony Cooper.
email: tony.cooper at virgin.net
Allow at least 10 working minutes for reply. ;)






More information about the Diy_efi mailing list