Hey I'm new

[Steve Ravet]

BIGED2022 at aol.com wrote:
> 
> More specifically,  during that first minute of running is my 7747 ECM using a
> "cold engine" enrichment factor found somewhere in the prom or is it running
> on some open loop parameters that are not found in the EPROM?
> Oh one other thing.  In the tables listed in programming 101. are those real
> values ie timing in degrees or are they the actual prom table values that will
> be factored?
> Thanks again guys!

There is a section of the programming 101 page that talks about the
units that the tables are in.  The timing table is not in degrees, for
example.  To convert a timing table value to degrees, do this: 
X*90/256  where x is the value from the table.  Each table has a
conversion function, they are listed on the prog 101 page in the section
called "units"

--steve 

-- 
Steve Ravet
steve.ravet at arm.com
Advanced Risc Machines, Inc.
www.arm.com