CarPROM software ???

andy quaas realsquash at yahoo.com
Tue Nov 10 19:31:16 GMT 1998


So this "mastertune" software knows where all the tables are?  Does it
matter which ECM it is or does it somehow analyze the code in the
eprom?  Anyone got screenshots?

Andy Q


---Mark Romans <romans at pacbell.net> wrote:
>
> I have a friend who bought the carprom software and showed it to me.
 My
> opinion is that CARPROM is worthless. He felt he was ripped off. 
Buy Master
> Tune.  It works.
> Mark
> -----Original Message-----
> From: Steve Ravet <steve.ravet at arm.com>
> To: diy_efi at efi332.eng.ohio-state.edu
<diy_efi at efi332.eng.ohio-state.edu>
> Date: Monday, November 09, 1998 11:52 AM
> Subject: Re: CarPROM software ???
> 
> 
> >andy quaas wrote:
> >>
> >> Anybody heard of this carprom software from arizona speed and
marine?
> >> Found it on their webpage.  Its for editing "GM ecms and pcms".  Is
> >> this stuff any good?
> >
> >>From looking at their WWW page, it looks very similar to promedit,
which
> >is available here on the ftp site.  Their carprom doesn't have
knowledge
> >of where tables lie in the eprom image, so you have to figure it out
> >yourself.  If you are going to do that much work, might as well use
> >promedit on the WWW page for free as pay for their program.  It's not
> >clear to me if AZSPEED includes information about table locations for
> >some or any GM ecms.
> >
> >--steve
> >
> >>
> >> Andy Q
> >>
> >> _________________________________________________________
> >> DO YOU YAHOO!?
> >> Get your free @yahoo.com address at http://mail.yahoo.com
> >
> >--
> >Steve Ravet
> >steve.ravet at arm.com
> >Advanced Risc Machines, Inc.
> >www.arm.com
> >
> 
> 

_________________________________________________________
DO YOU YAHOO!?
Get your free @yahoo.com address at http://mail.yahoo.com




More information about the Diy_efi mailing list