Fuel pressure / Flow rate formula

[Bruce Plecan]

-----Original Message-----
From: d houlton x0710 <tc75918 at hpr357.msc.az.boeing.com>
To: diy_efi at efi332.eng.ohio-state.edu <diy_efi at efi332.eng.ohio-state.edu>
Date: Tuesday, November 17, 1998 3:08 PM
Subject: Re: Fuel pressure / Flow rate formula


Big Snip


> It quotes RC Engineering and they 
>apparently swear by the Lucas disk type injectors. 

I just wonder if they just happen to sell them.

 They say they can run
>at 85% - 95% duty cycle with no ill effects and can handle higher pressure
>much better than the pintle type.  They can also run a much shorter pulse
>at idle than a pintle type because of the smaller lift needed for a disk
>type.  Something like a .8 - .9 ms opening time for the disk vs 2 ms or
>so for the pintle.

They mention if they were Peak+Hold?.  
Bruce
>
>
>--Dan
>