Min throttle plate opening & IAC

[Tug4x4 at aol.com]

Ahh ...the idle plug.  If you have a gold colored Idle plug with a small
protruding point you will need to do the following to remove it. 1. Grind the
tip off.  This is a surfaced hardened plug that will resist the best of the
drill bits.  2. center punch the new flat surface and drill a 1/8" hole.  BE
WARNED!  This plug is hardened at the other end also and will "grab" the bit
as you drill.  This can lead to broken off bits and other scary stuff.  3.
Insert sheetmetal screw into new hole and tighten.  4. Using 2 needle nose
pliers, PRY the offending plug from it's home.  Done this on just about every
Howell EFI conversion I've done up here in Colorado.  Good luck!!

Jim  @ PRO 4x4
498 EFI Mopar/ IH Scout