Delco 808 Diag Info
Justin Albury
vk2hja at ozemail.com.au
Wed Oct 7 05:56:51 GMT 1998
Just a little more info for those wanting to know
DIAGNOSTIC MODES
Diagnostic Pins A-B Resistance
Mode Voltage Drop Applied Across A & B
Data List 2.5V 10K
Field Service 0V 0K (Shorted to
Earth)
ECM Back Up 1.5V 3.9K
Normal 5.0V
Infinite
Terminal A is the ALDL Earth
Terminal B is the Diag Reguest enable which is pic A9 on the 808 which
is normaly at a 5V+ level
Terminal E is Serial Data Link/Check ing Light ........as for the check
engine light it is wired between A5 and 12+ via the ignition switch
Terminal F is the Torque Converter Clutch test point wired to A7
Terminal G is the Fuel Pump Test Point
Terminal H is Ignition feed for test gear
I hope this answers a few Questions
Juz!
More information about the Diy_efi
mailing list