injectors
Greg Hermann
bearbvd at sni.net
Fri Oct 9 02:41:23 GMT 1998
>In a message dated 98-10-08 14:54:28 EDT, you write:
>
><< No, but bungs that thread in and fit O-ring injectors are available, both
> 3/4 and 13/16 diam. threads.
> >>
>Where might one find this bungs? That would make my motorcycle project a
>bunch easier.
> thanks Mark
MSD Fuel Management (El Paso , Texas) Might be listed under
Autotronics---same outfit as does the ignitions. They have ones that thread
in and ones that epoxy or tig in. They also have ones that use a wire-form
clip to hold the injector between the bung and a fitting (which they also
have) which fits the top of the injector. The top fittings are available
either for silver soldering to a SS fuel rail (also available) or with
threads so as to run individual fuel pipes or hoses. They also offer a
Silver &Deming (reduced size shank) style drill reshaped so as to cut
appropriately shaped holes into a manifold, should you care to tig and
finish machine big enough bosses onto your manifold so as to do it this
way.
Kinsler Fuel Injection--Michigan
Blower Drive Service-California
Regards, Greg
More information about the Diy_efi
mailing list