motorcycle intake manifold
Greg Hermann
bearbvd at sni.net
Fri Oct 9 13:19:26 GMT 1998
>In a message dated 98-10-09 03:18:52 EDT, you write:
>
><< T-shaped pieces and connect them to
> each other with 1/2" rubber fuel hose and hose clamps to get the
> right spacing. They won't have barbs, but i can coarsely sand
> the ends of the tubing so the hose can stick better. Should this
> be okay up to about 50-60 PSI pressures? >>
> Wear a fire suit when riding. I tried using hose clamps on un barbed
>tubeing. They poped off around 50 PSI. About 30% of the time. I have run
>across injectors that use a barbed conn at the supply end. I'll find the web
>site and send it to you.
You might try hacking up some fuel rail tubing off an old Volvo or Vdub
D-Jetronic system--nice rounded barbs everywhere.
Regards, Greg
More information about the Diy_efi
mailing list