BBC AKSN

David A. Cooley n5xmt at bellsouth.net
Sun Oct 25 03:32:30 GMT 1998


Jason,
Sounds like the AKSN chip is meant for a different ECM than what you
have...  Possibly some inputs/outputs that are being fed from different
sources on the ECM that cal went with.

At 11:08 PM 10/24/98 -0400, you wrote:

>As for the symptoms... They are exactly as you describe, like the key on
>- off - on...... Like I said before if you look at the injector you can
>physically see the fuel stop totally....The oscillations must be fuel
>related because I still have good spark during this (verified by timing
>light on coil wire) and the IAC isn't moving but 1 or 2 positions either
>way.  Also while looking at Diacom during all this I get all kinds of
>weird things showing up like battery voltage dropping to 3.5V or going
>as high as 25V but DVOM hooked to battery says 14.3V steady.  Plus when
>it dies I get sporadic codes that diacom shows for 1 frame while it is
>stalling then they disappear once the engine has stopped, they do not
>get stored, as I said if I didn't have diacom I would never see the
>codes...I would normally think that is was a ground or ecm problem but
>it only happens with BBC AKSN.  I have not had this problem with any
>other chip... If anyone is interested in seeing a diacom file of this,
>let me know, I can send it...

===========================================================
           David Cooley N5XMT           Internet: N5XMT at bellsouth.net
     Packet: N5XMT at KQ4LO.#INT.NC.USA.NA   T.A.P.R. Member #7068
       I am Pentium of Borg...division is futile...you will be approximated.
===========================================================



More information about the Diy_efi mailing list