ask for help

[David A. Cooley]

You might search for PADS PCB software or ORCAD... I think both of those
allow importing of the Gerber files for modification.

-----Original Message-----
From: zhu zhong hua <sencomu8 at public.shenzhen.cngb.com>
To: diy_efi at efi332.eng.ohio-state.edu <diy_efi at efi332.eng.ohio-state.edu>
Cc: n5xmt at bellsouth.net <n5xmt at bellsouth.net>
Date: Tuesday, April 20, 1999 7:44 AM
Subject: Re: ask for help


>Dear David,
>      Thank you very much.  Now I can view the Gerber files.  But I
>can't find one tools to revise them.  Could you do me one more favor?
>
>     Regards,
>    zhu zhong hua
>
>David A. Cooley wrote:
>
>> At 04:00 PM 4/19/99 +0800, you wrote:
>> >Hi,Dear sir
>> >    I have downloaded fiel efi332v0_4final-pcb.zip from
>> >ftp://efi332.eng.ohio-state.edu/pub/efi332/hardware.  I unzipped the
>> >file and got several Gerber files.  But I can't open and use it by
>> >Protel.  Which tool was used to build such files?  And how can I open
>>
>> >them and use it for myself?  By the way,the hardware schematic are
>> all
>> >in postscript file format.  Who have pcb files for them?  So I can
>> use
>> >them using protel eda tool directly and need not to redraw them
>> again.
>>
>> You don't need Protel or any PCB software to view/print gerber files.
>> Search the net for GCPreview.  It allows you to load Gerber files and
>> display/print them.
>> ===========================================================
>>            David Cooley N5XMT           Internet: N5XMT at bellsouth.net
>>      Packet: N5XMT at KQ4LO.#INT.NC.USA.NA   T.A.P.R. Member #7068
>>    Sponges grow in the ocean... Wonder how deep it would be if they
>> didn't?!
>> ===========================================================
>
>
>
>