Plugs for flare fittings?
Onebil2mny at aol.com
Onebil2mny at aol.com
Mon Feb 8 14:51:50 GMT 1999
In a message dated 2/5/1999 12:34:34 PM Eastern Standard Time,
steve.ravet at arm.com writes:
<< If I wanted to remove the AIR pump on my V8 S-10 conversion, then I'd
have to find some flare plugs to plug the holes in the exhaust manifold
where the AIR connects, right? Any suggestions on where to find
something like that? I've called plumbing and A/C suppliers in my area
and can't come up with anything. A few places told me that if they had
them, they'd only be in brass. If I can find brass ones, would they
work? The manifold is cast iron and the AIR tubes are stainless. Will
brass take the heat cycling and temps? >>
Brass will work. I have seen theese plugs at Trak Auto. Also, a pipe plug
will work, I know, I've done it.
Bill K
More information about the Diy_efi
mailing list