intro, hyper7148

[Robert W. Hughes]

The C3 ecms at least have a card edge connector which allows access to
the processor bus and enough control to map out the on board ROM. A
circuit showing this connector for the 7170 can be found at
http://www.cruzers.com/~ludis/1227170sheet1.gif. Apparently this
connector is common to most of the C3s. You can use this to move all of
the software off of the board or as a monitor port for high speed
monitoring. This has been done (the monitoring part) for the GN. Check
out http://www.chuengineering.com/
-- 
Robert W. Hughes (Bob)
BackYard Engineering
Houston, Texas
rwhughe at hal-pc.org