Mail failure

[Msg Recipient]

TO: diy_efi                                                    DATE: 02/08/99
                                                               TIME: 10:31
SUBJECT: Mail failure
------------------------------------------------------------------------------

[008] Unable to deliver mail due to mailbag contention.
Message was not delivered to
  KOHLERNET/GENERATORS/NassJeff (KOHLERNET/GENERATORS/NassJeff)

------------------------------------------------------------------------------
   Date: 1999-02-08 10:26
   From: diy_efi [MCI:diy_efi \ EMS: INTERNET \ MBX:
diy_efi at efi332.eng.ohio-state.edu]
     CC: KOHLERNET/GENERATORS/NassJeff
     To: DIY_EFI List [MCI:DIY_EFI List \ EMS: INTERNET \ MBX:
DIY_EFI at efi332.eng.ohio-state.edu]
Subject:  re:intro, hyper7148

---------------------------------------------------------------------------

MCI Mail date/time: Mon Feb 08, 1999 11:24 am  CDT
  Source date/time: Mon, 08 Feb 1999 10:23:35 -0600
-------------------

The C3 ecms at least have a card edge connector which allows access to
the processor bus and enough control to map out the on board ROM. A
circuit showing this connector for the 7170 can be found at
http://www.cruzers.com/~ludis/1227170sheet1.gif. Apparently this
connector is common to most of the C3s. You can use this to move all of
the software off of the board or as a monitor port for high speed
monitoring. This has been done (the monitoring part) for the GN. Check
out http://www.chuengineering.com/
--
Robert W. Hughes (Bob)
BackYard Engineering
Houston, Texas
rwhughe at hal-pc.org