Water Injection Thread [now U joints]

[Jim Davies]

On Fri, 8 Jan 1999, Greg Hermann wrote:

> >> > > For the work-a-holics, just make a drive shaft using an old shaft,
> >>some 1/4
> >> > > plate steel, a lathe, welder, and an axle from a FWD GM midsize.
> >> > The real work-a-holics use a hacksaw.  And don't tell me I can't cut a
> >> > straight line with a hacksaw.
> >> > Shannen
> >>
> >For a mere $19.95 plus shipping+handling I ship you the manual.  ; )
> >It's a skill older than lead bodyfiller.
> >Shannen
> 
> I believe that pipe fighters call it a "pipe-wrap"
> 
> >> using the wooden jig I made, so I asked a friend to
> >> fabricate them from scratch.  Less balancing issues, one
> >> piece, no worries about welds giving out (I don't weld as
> >> good as most), etc.
> >>
Not that you should do this but...if you must cut a thin wall tube
straight buy a KD roller type exhaust pipe cutter, set up carefully and
rock on.