Haltech E6GM

[Bruce Plecan]

-----Original Message-----
From: Charles Brooks <cbrooks1 at mail.tqci.net>
To: diy_efi at efi332.eng.ohio-state.edu <diy_efi at efi332.eng.ohio-state.edu>
Date: Friday, January 15, 1999 8:39 PM
Subject: Re: Haltech E6GM


>Is the E6GM capable of 500 RPM resolution? It's hard to tell
>from the Haltech page, and the post in the archives didn't
>elaborate. If so then I don't see any problem for my
>application. Hhmm, seems like I'm trying to talk myself into
>the Haltech unit, A 500 dollar difference is a persuasive
>argument  :)

If you find the demo software go - or + on the fuel timing table,
and you should see the 500 rpm steps off of Alt F tables it is
1000 rpm steps.  Sounds confusing til ya read/see the manual.
Bruce,  and does show very fine resolution in idle fuel as GH
mentions.
>
>Charles Brooks
>
>
>
>Bruce Plecan wrote:
>>
>> 1,000 rpm for a 12,000 rpm capacity calibration, 500 rpm resolution for a
>> 6,000 rpm calibation.  Meaning no correction over 6,000 rpm not
>> that the ecm wouldn't work at higher speeds.
>> Bruce
>