Another Non EFI Question

[Jim Davies]

On Thu, 21 Jan 1999, Peter Fenske wrote:

> 
> 
> Hi All
> 
> Hate to ask you another non efi guestion but
> on a dana 44 if when replacing a gear set
> The replacement pinion is stamped +0
> which is replacing a pinion stamped +1
> 
> This means I need a shim which is +1 thou
> bigger..
> 
> Question is the pattern gonna be off significantly
> if I use the old shim.
> 
No. 1 thou will not make a difference. Quite a few mfrs only offer shims
in 2 thou steps ...

My 2 cents, based on a few hundred Dana 35 to 70 ratio changes.