Another Non EFI Question

[WAYNE JOHNSON]

+ means move it toward front of car. IMHO .001"  won't make that much
difference, but to do it right  you should check the pattern with gear
marking compound. Backlash may have to be adjusted, just remove thickness
from one side and add the same amount to the other side. Shoot for
.004-.008 backlash with pattern centered on drive side of tooth.

On Thu, 21 Jan 1999 23:43:22 -0800 "Peter Fenske" <pfenske at bcit.bc.ca>
writes:
>
>
>Hi All
>
>Hate to ask you another non efi guestion but
>on a dana 44 if when replacing a gear set
>The replacement pinion is stamped +0
>which is replacing a pinion stamped +1
>
>This means I need a shim which is +1 thou
>bigger..
>
>Question is the pattern gonna be off significantly
>if I use the old shim.
>
>TIA:peter
>
>
>

___________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
or call Juno at (800) 654-JUNO [654-5866]