dual spray injectors

[ECMnut at aol.com]

Not sure if I fully understand you... You have a "single spray" style
of injector right now, but want a slightly larger "two hole" injector?
Or do you want an additional small injector on each cylinder?
I have a shot of the two-hole injector at:
   http://www.enzoco.com/mike/injector/
It is #4 in the group of pics..  Would something like that work,
or are your current injectors pointed noticably toward one 
intake valve in each runner?  If you go the add-on route,
I have lots of 15 pound units.. Write me off-list if you need'em.
Mike V

>  Right now, I have 24 pound/hour injectors (DENSO for Ford), in the 14 Ohm
>  range.  I wouldn't want to go much over 30# at this time.  Fitting the
>  existing fuel rails would be a big plus.  These are the ones with O-Ring
>  seals at each end, ~14mm diameter, 84mm length (seal to seal).
>  
>  Because the existing injector is so well places, I am starting to think
that
>  I might be better off to add a second set.  Does anyone know if there are
>  smallish ones, for about 12-15 pounds/hour that Ford uses anywhere?