More DFI q's...
Bruce Plecan
nacelp at bright.net
Fri Jan 29 00:45:29 GMT 1999
-----Original Message-----
From: Stuart Bunning <stuart at kenelec.com.au>
To: diy_efi at efi332.eng.ohio-state.edu <diy_efi at efi332.eng.ohio-state.edu>
Date: Thursday, January 28, 1999 6:43 PM
Subject: Re: More DFI q's...
Don't be stunned by the silence to follow that comment.
Lots of folks will consider that a really good idea, but not much
action. Darn few folks will give up something as time consumming
as a map, or prom address.
Bruce
>
>I agree.... Although no two engines are the same it sure does help to
>compare maps from different configurations. It sure helps when you are
>starting from scratch.
>I am willing to setup such a page if anyone is interested in the idea and
>interested in sending me the data to compile such a page.
>
>ANYONE ELSE INTERESTED ?????????
>
>>>>I think if we can start a section on the homepage with maps (fuel and
>>>>timing) from various engines, factory tuned or not, it would be of great
>>>>help to those building/programming their own systems.
>>>>
>>>>Any comments or suggestions? Thanks in advance.
>>>>
>>>>
>>>>Matt Beaubien
>>>>mbeaubie at ualberta.ca
>>>>3 x 510
>>>>1 x 300ZXT
>
>
>
>
>
>Best Regards,
>
>STUART BUNNING
>SALES ENGINEER
>KENELEC PTY LTD
>
>23-25 REDLAND DRIVE
>MITCHAM VICTORIA 3132
>AUSTRALIA
>
>PHONE: 61 3 9873 1022
>FAX: 61 3 9873 0200
>EMAIL: stuart at kenelec.com.au
>WEB: http://www.kenelec.com.au/
>
More information about the Diy_efi
mailing list