Prowler V6

[dzorde at erggroup.com]

Surely not, these are the type you just go to the local hardware and get (not
high tensile), still shiny plating on them and its a big hardware chain so stock
should be replenished quite often. Maybe its the Asian version of the imperial
sizes.  Use a 10mm casting but thread it to 3/8" ?

Dan  dzorde at erggroup.com





Shannen Durphey <shannen at grolen.com> on 03-06-99 11:55:52 AM

Please respond to diy_efi at efi332.eng.ohio-state.edu

To:   diy_efi at efi332.eng.ohio-state.edu
cc:    (bcc: Dan Zorde/Transit/ERG_Group)

Subject:  Re: Prowler V6




dzorde at erggroup.com wrote:
>
> Yeah, there are the Asian metric sizes (like 12mm, 15mm, 18mm hex heads) and
> European metric sizes (like 13mm, 17mm, 19mm hex heads).  And lately I have
> started finding 3/8" nuts and bolts with 15mm hex heads (I was quite surprised
> to find that neither a 9/16" or a 5/8" ring spanner would fit, but a 15mm did)
>
> Dan  dzorde at erggroup.com
>
Once upon a time, American wrench sets came with a 19/32" wrench.
This works out to 14.5 mm.  Any chance this is what you have found?
Shannen