Injector geometry

[C. Brooks]

Would you happen to have pics of the final product and/or your home made
tooling???

Charles Brooks

-----Original Message-----
From: James Weiler <james at brc.ubc.ca>
To: diy_efi at efi332.eng.ohio-state.edu <diy_efi at efi332.eng.ohio-state.edu>
Date: Sunday, June 06, 1999 4:02 PM
Subject: Re: Injector geometry


>
>I made a jig for a drill press and did everything myself.  The bosses
>have no more than about 0.5mm variation between them.  You might want to
>think about the fuel rail and what kind of clearance/installation angle
>it can be at before you start drilling holes.  I used D-section aluminum
>fuel rail from Arizona speed and marine (they have a web site).  They
>sell it as a 6 foot section, but you'll only need 1/2 of that ...now you
>just HAVE to do another engine :)
>I think next time I'll just make my own fuel rail from bar stock.
>This was all done using an Edelbrock Torqer (single plane) for a Boss 351.
>
>HTH,
>jw
>
>