Dual fuel PFI rails....

[SPECTRO COATING CORP.]

> Making an additional fuel rail is really not that complex.  The key is
> making it simple enough to machine out using fairly common tools.
>
> What I would recommend is getting some 3/4" rectangular bar stock, and
> have a machine shop bore the length of it, thus allowing fuel to go
> through the lenth of the bar.  Then, being square, you can place it
> flat on your drill press, and mill out injector holes.  The injector
> holes need to be slightly smaller than the O-ring that's on the
> injector, and you push the injector/O-ring into the fuel rail.  This
> is the easiest way.
>
Wouldn't it be easier just to buy the fuel rail stock - its not that
expensive and it sure beats paying some one to drill the length of the bar
stock? (which would be a PITA unless you were set up for it)

I bought mine from Rob at force fuel injection and its not that expensive
$9.00/ft i think

Just my $.02

Jason