Off Panhard bar

[Bruce Plecan]

-----Original Message-----
From: H. J. Zivnak <bztruck at email.msn.com>
To: diy_efi at efi332.eng.ohio-state.edu <diy_efi at efi332.eng.ohio-state.edu>
Date: Saturday, March 13, 1999 3:40 PM
Subject: Re: Off Panhard bar

What's not symmetrical about the triangle?.  Or are you assuming the
Triangle is
mounted off center?.
Bruce


>>Particularly if you replaced the chassis pivots of the triangle (rubber
>>stock) with bronze on steel, also if you replaced the lower rod ends with
>>real rod ends, they were as NICE a live rear axle setup as you could want.
>(Lurk mode off)
>It's nice to have something to say !
>I disagree.
>Any assymmetry of the linkage will cause the car to react differently in
>right hand turns than it does in left hand turns. Secondly, because the
>A-arm is above the axle, and it determines the roll center heighth, the
roll
>center is high.