FI fuel line

[Mike Pilkenton]

OK, thanks for the advice from everyone.  I will run the metal line the
length of the car and use the rubber hose for the end connections.  I assume
then that no one has had any problems with the hose clamps that come with
the efi rubber hoses?  These would certainly make connections easier than
metal fittings as well as allowing flex between the engine and frame.

Mike
-----Original Message-----
From: Clarence L.Snyder <clare.snyder.on.ca at ibm.net>
To: diy_efi at efi332.eng.ohio-state.edu <diy_efi at efi332.eng.ohio-state.edu>
Date: Saturday, March 20, 1999 5:23 PM
Subject: Re: FI fuel line


>If you are thinking of running rubber from end to end, just one word.
>DON'T.
>In many juristictions it is illegal, and in all cases it is unsafe. Run
>steel or aluminum fuel line, properly supported, regardless how much
>time and effort it takes. At the cost of EFI rubber hose, it makes sense
>from an economic view as well.
>