FI fuel line

[Bruce Plecan]

-----Original Message-----
From: Vinnie Moscaritolo <vinnie at vmeng.com>
To: diy_efi <diy_efi at esl.eng.ohio-state.edu>
Date: Tuesday, March 23, 1999 12:33 PM
Subject: Re: FI fuel line

Earl's, er maybe russell makes the fitting...
I just ran a single Mallory 15PSI Pump by the tank and all is well.
Red or Blue for Holley's ain't enough pressure (IMHO)
Bruce


>
>
>At 5:00 AM -0500 3/23/99, Vance Rose wrote:
>> Have done the same also - works very nice. Saw a post where someone
silver
>> soldered joints in tubing to make custom lines. Only way i've found to
get
>> saginaw ends for my pu.
>>
>
>
>I wanted to use AN fittings in conjunction with my Holley TBI unit.
>Since Holley used a non-standard thread (or at least one I couldn't
>find. maybe they are Saginaw..) on the TBI and I couldnt find an
>adapter to AN, I cut the Holley connector and silver soldered
>(welded) it to a steel AN fitting.  I also did the same thing to the
>Holley supplied (Carter?) fuel pump..
>
>Not to change the subject much but speaking of Holley EFI's I have
>heard that some folks run a primary pump (Holley Red pump)  near the
>tank and then the high pressure pump closer to the TBI. I am curious
>if this is necessary and  how many people actually do this?
>
>
>Vinnie Moscaritolo
>http://www.vmeng.com/vinnie/
>PGP: 3F903472C3AF622D5D918D9BD8B100090B3EF042
>-------------------------------------------------------
>
>Those who hammer their swords into plows,
>will plow for those who don't."
>