injector manifold design

[Stowe, Ted-SEA]

yes there is the crossflow head, without valves it sells for about $1200.00,
that's without it begin polished or anything. you need a special intake
manifold for that too, which is around 400.

-----Original Message-----
From: Mike Morrin [mailto:mikem at southern.co.nz]
Sent: Tuesday, March 23, 1999 1:08 AM
To: diy_efi at efi332.eng.ohio-state.edu
Subject: RE: injector manifold design


At 01:06 pm 22/03/99 -0800, Stowe, Ted-SEA wrote:
>I see, thanks.
>
>that is a nasty problem, and yes it would be a lot of work to resolve. 
>but I am wondering what is so different from the carb setup on it now. the
>same problem must be there I think. ?

You could fit an 8 port head.  I recently saw an MGB engine with an 8 port,
aluminium, cross-flow, after-market head.  
I suppose you had not budgetted for that....

regards,

Mike