injector manifold design

[AL8001 at aol.com]

On a engine with two valves per intake port and one inj per port,   why not
aim the injector towards the cylinder that's lean?  Might not be directly
towards the lean cyl, just slightly towards it. Make a 2 or 3 piece adjustable
injector boss that will allow for the spray pattern to be adjusted left to
right and up and down.  

The inj mounting would have  bushing "A" drilled off center this would fit
inside Bushing "B",  "B"  would be drilled diagonal bushing "C" would be
welded to the intake. All bushings would have a O ring seal, set screw, and
some way to turn the bushing.

Another solution would be to have a o ring large enough to allow the inj to
swivel.

Harold