Emulator boards

[steve ravet]

Dave -- what board house did you use?  I'll put them on my "do not use"
list.

--steve

David Cooley wrote:
> 
> After the family crisis and the system crash I bailed out in SC, they sent
> me to Ft. Bragg to do an installation at Womack Army Hospital. Kept us
> there until the acceptance testing was out of the way and I got back
> Saturday night. Went thru the boards last night and noticed they all seem
> to have areas where the data/address lines are either missing copper or are
> covered solid in one or two places. Verified my drawings had .010 spacing
> and .010 minimum line width, PCB house spec'd at .008 minimum spacing and
> .008 line width. Spoke with them about 30 minutes ago and they stated they
> were having problems with some of their processing equipment... they said
> if I would have been willing to pay the $200.00 "UL testing fee" it would
> have caught the errors. Regardless, this is the 2nd time I've been hosed
> and they agreed to refund the cost. Everyone that has sent me a check
> please send me a note with an address so I can get the money returned.
> For a 100.00 item, this has been a ridiculous battle.
> Thanks,
> Dave
> 
> ===========================================================
> David Cooley N5XMT Internet: N5XMT at bellsouth.net
> Packet: N5XMT at KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
> We are Borg... Prepare to be assimilated!
> ===========================================================
> 
> ----------------------------------------------------------------------------
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org

-- 
Steve Ravet
steve.ravet at arm.com
Advanced Risc Machines, Inc.
www.arm.com
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org