4 Bar MAP sensor for DFI

[Bernd Felsche]

John Andrianakis writes:

>I have seen 4 bar map sensors with 0-5v output in a Bosch racing products
>catalog. Unfortunately I dont have the catalog so you will have to locate a
>Bosch dealer.

>----- Original Message -----
>From: Flanagan, Stephen CECOM RDEC STCD <Flanagas at mail1.MONMOUTH.ARMY.MIL>


>> Does anyone have info on a 4 Bar MAP sensor that can be used to
>> replace a 3 Bar sensor on a ACCEL DFI system.  I am running an
>> excess of 35 lbs of boost and the DFI is only mapped up to 3 Bar
>> or roughly 30 lbs of boost.  I would like to substitute the 4 bar
>> sensor for the 3 bar sensor, and lie to the map. My one concern
>> is if the output of the 3 Bar sensor is relative to the output of
>> the 4 Bar sensor.  I am guessing here but for Example: on the 3
>> Bar sensor, voltage output is 0 - 5 volts which equals 0 to 3
>> Bar.  For the 4 Bar sensor, 0 - 5 volts should equal 0 - 4 Bar.

>> I am looking for a specs on the 3 bar and 4 bar sensors and some
>> feedback if anyone has tried something like this in the past.

Try http://www.mot-sps.com/senseon/pressure_SG.html

Integrated sensor, compensated with ranges up to 700kPa or 1000kPa.

-- 
Real Name: Bernd Felsche
    Email: nospam.bernie at perth.DIALix.com.au
     http://www.perth.dialix.com.au/~bernie - Private HP
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org