Ford crank sensor

[Mike Blakey]

I have modified the flywheel on a ztec (iron block, escort) by removing 5mm from 
the rear face. the upshot of this is that the crank sensor will no longer work.
does anyone know of an alternative sensor that could be used. The ford sensor seams 
to be a VERY simple device of a coil (400ohms and a magnet) and most of the 
replacement inductive proximity detectors( which would be easy to fit ie 8mm 
threaded body) require supply and are signal conditioned, so im assuming they will 
not interface directly with the ecu. Any ideas?
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org