Ignition Only

Shannen Durphey shannen at grolen.com
Tue Nov 7 02:38:57 GMT 2000


The 730's cousin, 749, was used with a DIS equipped quad 4 engine and
auto trans in some Pontiac and Oldsmobile cars.
Shannen

rr wrote:
> 
> Don't know much of anything about the engine. However, there are GM ecms
> available that run a DIS that should work. All that is required to run ignition
> only, is to turn off the error codes for the fueling. Then setup the SA tables as
> you need them. A minimum of sensors are required: MAP, crank, coolant,
> vss. I think the '730 has been used on 4-cyl DIS, but am not positive.
> 
> BobR.
> 
> Tom Parker wrote:
> 
> > matt <matthewgreen at powersoft-services.co.uk> wrote:
> >
> > >What options do I have on the DIY front for running
> > >the ignition ? as my engine (Vauxhall 2.0 16v ECO TECH) has no
> > >place for a distributor .
> >
> > >ECU's for ignition cost about 350 ukpounds.. are there any other
> > >options for me ?
> >
> > Could you run the ignition from the original EFI computer and just not connect
> > the injection system? Would the computer complain if there were no
> > injectors connected? You might have to include the oxygen sensor. You would
> > have to include the air sensors on the inlet mainfold. If it is MAF you might
> > have some problems but if it is MAP I would expect it to work.
> >
> > --
> > Tom Parker - parkert at ihug.co.nz
> >            - http://www.geocities.com/MotorCity/Track/8381/
> >
> 
> ----------------------------------------------------------------------------
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org




More information about the Diy_efi mailing list