Motronic Question - load?

[Jörgen Karlsson]

> Load is used on all Motronic maps. Load is defined as how well
> the cylinder is filled. The input that determines load is the
> barn door or hot wire. But the barn door is maxed out between
> 3,000 and 4,000 RPM. How is load determined above that point?

If I know Bosch right they just check the knock sensor, if it start yelling
they dump some fuel and retard ignition... Ok, I am kidding, but I wouldn't
be supriced if this is what they do...

Jörgen Karlsson
Gothenburg, Sweden

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org