EGOR Interface - Display

[Bruce Plecan]

From: "Axel Rietschin" <axel_rietschin at compuserve.com>
> > > Hell rather then redesigning what's been done why not work on a
display
> > and interface to a 0-1 v output?.
> > > That is something critical to any design.
> > > Bruce
> > Display? How about a simple ROM look up table. You can accommodate any
non
> > linearity's by storing the calibration factors in the ROM.
> > Example. Use a 12 bit A/D converter on the 0V to 1V output. Use the
> digital output to address the ROM. Add a simple digital display driver to
the
> output of the ROM. You can have several curves stored in the ROM:
> > 1. Analog voltage
> > 2. Lambda
> > 3. Air Fuel ratio
> > A simple switch that changes the upper address to the ROM will allow you
> to switch between the three.

> This is just where you go digital, no?   :)

Thank you for contributing to the issues at hand !!!!!!!!!!!!!
You have anything to contibute?
In a meaningful way?.
Not to offend
Bruce


> Axel

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org