Source for small throttle bodies

[Erik Petersen]

You can also find the carter bbd on late 70's early 80's AMC 258 I6.

I'm replacing the bbd in my '79 CJ5 with a homemade MPI solution.

-erik

-----Original Message-----
From: owner-diy_efi at diy-efi.org [mailto:owner-diy_efi at diy-efi.org]On
Behalf Of J. Creech
Sent: Monday, October 30, 2000 5:14 PM
To: diy_efi at diy-efi.org
Subject: Re: Source for small throttle bodies


I've seen 'em (the Holley) on lots of pickups all the way up to about '85 or
so, when Chrysler dropped the slant. Seen lot's of the Carter carbs too. You
can also find the Holley on 318's and 360's  as well.

Scott Creech


----- Original Message -----
From: "Matt Cramer" <mac9 at po.cwru.edu>
To: <diy_efi at diy-efi.org>
Sent: Sunday, October 29, 2000 9:56 PM
Subject: Re: Source for small throttle bodies


> At 07:45 PM 10/29/2000 -0600, you wrote:
> >Probably Holley was the Mfgr. Their 1 bbl carbs are built the same way,
and
> >both are on thousands of Slant-Six's.
>
> The only factory two barrel carb that I know of installed on slant sixes
> was the Carter BBD.  This setup was called a "Super Six," and was only
> offered in the late 70's - at least in the States.  However, Carter BBD's
> turned up on a wide variety of Chrysler products from the 60's and 70's.
> I've got one installed onto my Dart, although I can't remember if it has
> the detatchable throttle plate you describe.
> Finally, a question on this list I can answer! :-)
>
> Matt Cramer
> --------------------------------------------------------------------------
--
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org