Bosch O2 / Sensor ,any good ?

[rr]

Should work just fine for that. The wiring might be as follows:

    White wires: +12v & ground for heater.

    Black: signal out
    Gray: signal ground (may also be attached to shell)

BobR.


Dr Flowgood wrote:

> I picked up a couple Bosch 02 sensors at a swap yesterday. Can I use this with a good
> volt meter for a relative rich/lean indicator ?  I just want to experiment with them on
> my old Camaro. (carb) My question is, are these any good and what should they cost ?
> its a 4 wire unit.
>
> It says this on it:   Bosch 08429A0           982
>                            0258 005 791/792   12v
>                            Ford F8TF-9G444-CA OD29
>
> Thanks a bunch   ( be easy on me  :')
>
>                Doug J
>
> ----------------------------------------------------------------------------

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org